I was just wondering if there'll be support for widescreen resolutions in Tremulous 1.2. (i don't know is 1.2. will be based on quake 3 or 4)?? (In Tremulous 1.1 i was trying to have WS resolution by some commands ("+r_mode -1 +r_customWidth 1280 +r_customHeight 800") but it does not work)
r_width
r_height
Had the same problem as you :)
WE HAVE A TROUBLESHOOTING SECTION FOR ANY QUESTIONS YOU MIGHT HAVE, SIR.
Quote from: Biszkhopt on October 17, 2008, 01:50:19 PM
I was just wondering if there'll be support for widescreen resolutions in Tremulous 1.2. (i don't know is 1.2. will be based on quake 3 or 4)?? (In Tremulous 1.1 i was trying to have WS resolution by some commands ("+r_mode -1 +r_customWidth 1280 +r_customHeight 800") but it does not work)
Error message?
As I said, at least in TremFusion (which can be considered as "1.2"), r_customwidth and r_customheight variables become r_width and r_height respectively.
For r_mode, you don't need to modify this value though in my autogen.cfg it becomes "3".
Quote from: TheLuciferSausage on October 18, 2008, 01:03:15 AM
As I said, at least in TremFusion (which can be considered as "1.2"), r_customwidth and r_customheight variables become r_width and r_height respectively.
For r_mode, you don't need to modify this value though in my autogen.cfg it becomes "3".
tremfusion isn't 1.2
Quote from: kevlarman on October 18, 2008, 02:19:35 AM
Quote from: TheLuciferSausage on October 18, 2008, 01:03:15 AM
As I said, at least in TremFusion (which can be considered as "1.2"), r_customwidth and r_customheight variables become r_width and r_height respectively.
For r_mode, you don't need to modify this value though in my autogen.cfg it becomes "3".
tremfusion isn't 1.2
So what's 1.2?... if it exists at all? A mod?
tremulous 1.2 hasn't been released yet.
It's +set cvar value not +cvar value.
+set r_mode -1 +set r_customWidth 1440 +set r_customHeight 900 works for me.
+cvar value works as well
nice necro anyway :P